Add or replace a voice-over
Esta página aún no está traducida; aquí tienes la versión en inglés.
Open a finished clip and ask its chat for narration. Say the language, whether it covers the opening or the whole video, and the tone:
Add a calm English voice-over to the opening. Keep the original sound under it and lower the music.
Replace the full Chinese narration with this script. Keep the timing and use a voice already installed on this Mac.
Choose a voice
Section titled “Choose a voice”Reelfold chooses from the voices available to the current project and language. Local narration uses downloaded models; hosted voices need the corresponding provider configured. See Voices to download or change a voice.
Replace a take
Section titled “Replace a take”A new full narration that overlaps an earlier full narration replaces that earlier narration and its captions. It does not stack both voices. Undo brings back the previous take. An opening-only narration applies to its requested range.
Review the render
Section titled “Review the render”Open the clip and let any pending render finish. Play the resulting video in Transcript or Timeline to hear the updated mix. Check the words, pronunciation, narration level, original sound and captions together. Holding C in the editor previews the original source, so it will not include a newly added narration.
If rendering stops, keep the last good output and use Try again after resolving the reported cause. Narration is an edit to the output; it does not overwrite your original footage.